Mil-spec lower parts and upgrades for your AR's receiver.
Finished your 80% lower? Grabbed a stripped receiver that you're ready to assemble? We've got you covered with all the AR lower assembly components you need -- or want to upgrade! Check out the mil-spec LPKs we have in stock. They work with all fabricated 80% units and every mil-spec "retail" lower on the market, including the various calibers you might own: 9mm, 5.56, .223, .308, 300 BLK and more.
The stock AR trigger gets the job done, sure. But you can enjoy better shot placement and a more ergonomic grip with a few easy drop-in upgrades. We've partnered with Rise Armament, JMT, PSA, Hogue, and other top AR parts makers to offer up some of the best performance triggers and grips available for the AR platform.
It's surprisingly easy! Whether you finished an 80% lower or bought a stripped lower, the process is the same. We've got a detailed, step-by-step picture guide to walk you through the entire process. You'll want to grab a few basic gunsmithing tools, too. That includes a set of roll pin punches and a small gunsmith hammer. We've got also vice blocks and roll pin tools to make the hard stuff easier. Grab 'em all here.
You'll need the following parts, which can all be found right on this page:
DISCLAIMER: If you are new to the world of DIY gun building, you likely have a lot of questions and rightfully so. It’s an area that has a lot of questions that, without the correct answers, could have some serious implications. At AR-15LowerReceivers.com, we are by no means providing this content on our website to serve as legal advice or legal counsel. We encourage each and every builder to perform their own research around their respective State laws as well as educating themselves on the Federal laws. When performing your own research, please be sure that you are getting your information from a reliable source.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither AR-15LowerReceivers, a/k/a Tactical Gear Heads, LLC nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.
We are a national retailer of individual components and not all products depicted on this website are legal in every state. Shipping of various products found on this website are prohibited to some states (such as California, Connecticut, District of Columbia, Hawaii, New Jersey, New York, Rhode Island, and Washington). The information, pictures, text or products presented on this website are not a representation by us, and should not be understood by you, that any product or completed firearm is legal to assemble or own in your state of residence. We encourage each and every builder to perform their own research about the state and federal laws that apply to them. It is your responsibility to understand the law and we encourage you to consult with an attorney or your local ATF representative.